Campbell CR1000 User Manual

Appendix B. Status, Settings, and Data Table Information (Status/Settings/DTI)
Specifies the addresses of up to two domain name
servers that the CR1000 can use to resolve domain
names to IP addresses. Note that if DHCP is used to
resolve IP information, the addresses obtained via
DHCP are appended to this list.
Table 172. Status/Settings/DTI: E
Keyword
Alias,
Access,
Description
Read/Write,
DataType,
Units
Default
Value
Normal
Range
ErrorCalib
Keyboard: Status Table ≈ line 30
CRBasic: variable = status.keyword
Number of erroneous calibration values measured.
Erroneous values are discarded. Auto-calibration
runs in a hidden slow-sequence scan. See section
CR1000 Auto Calibration — Overview
(p. 92).
read-only
LONG
Count
0 0
EthernetEnable
Keyboard: Settings (TCP/IP) ≈ line 2
Settings Editor: Ethernet Interface Enabled
CRBasic: variable = settings.keyword;
SetSettings()
read/write
BOOLEAN
True
True or False
EthernetPower
Keyboard: Settings (TCP/IP) ≈ line 6
Settings Editor: Ethernet Power
CRBasic: variable = settings.keyword;
SetSettings()
read/write
UINT2
minute
0 to 4, 4 =
always off
Table 173. Status/Settings/DTI: F
Keyword
Alias,
Access,
Description
Read/Write,
DataType,
Units
Default
Value
Normal
Range
FilesManager
Settings Editor: Files Manager
Keyboard: Settings (General) ≈ line 11
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the numbers of files of a designated type
that are saved when received from a specified node.
See section Files Manager
(p. 384).
read/write
STRING
(0, , 0)
0 to 351
characters
FTPEnabled
Keyboard: Settings (TCP/IP) ≈ line 36
Settings Editor: FTP Enabled
CRBasic: variable = settings.keyword;
SetSettings()
Set to 1 if the FTP service should be enabled. This
service is disabled by default. Aliased to now
obsolete ServicesEnabled()
read/write
BOOLEAN
False
True of False
FTPPassword
Settings Editor: FTP Password
Keyboard: Settings (TCP/IP) ≈ line 22
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the password that is used to log in to the
FTP server.
read/write
STRING
0 to 63
characters
616

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4