3. Initial Inspection
• Check the Ships With tab at http://www.campbellsci.com/CR1000 for a list
of items shipped with the CR1000. Among other things, the following are
provided for immediate use:
o Screwdriver to connect wires to terminals
o Type-T thermocouple for use in the System Quickstart
(p. 41) tutorial
o A datalogger program pre-loaded into the CR1000 that measures power-
supply voltage and wiring-panel temperature.
o A serial communication cable to connect the CR1000 to a PC
o A ResourceDVD that contains product manuals and the following starter
software:
Short Cut
PC200W
DevConfig
• Upon receipt of the CR1000, inspect the packaging and contents for damage.
File damage claims with the shipping company.
• Immediately check package contents. Thoroughly check all packaging
material for product that may be concealed. Check model numbers, part
numbers, and product descriptions against the shipping documents. Model or
part numbers are found on each product. On cabled items, the number is
often found at the end of the cable that connects to the measurement device.
The Campbell Scientific number may differ from the part or model number
printed on the sensor by the sensor vendor. Ensure that the expected lengths
of cables were received. Contact Campbell Scientific immediately if there
are any discrepancies.
• Check the operating system version in the CR1000 as outlined in the section
Sending the Operating System (OS)
(p. 117), and update as needed.
39
To Next Page
Loading...
Need help?
General
