Campbell CR1000 User Manual

Appendix A. CRBasic Programming Instructions
Syntax
CWB100RSSI(CWBPort)
A.5.10 Peripheral Device Support
Multiple SDM instructions can be used within a program.
AM25T
Controls the AM25T analog-voltage input multiplexer.
Syntax
AM25T(Dest, Reps, Range, AM25TChan, DiffChan, TCType, Tref,
ClkPort, ResPort, VxChan, RevDiff, SettlingTime, Integ,
Mult, Offset)
AVW200
Controls and collects VSPECT
(p. 532) data from an AVW200 vibrating-wire
measurement device.
Syntax
AVW200(Result, ComPort, NeighborAddr, PakBusAddr, Dest,
AVWChan, MuxChan, Reps, BeginFreq, EndFreq, ExVolt,
Therm50_60Hz, Multiplier, Offset)
CDM_VW300Config
Configures the CDM-VW300 dynamic vibrating-wire spectrum analyzer.
Syntax
CDM_VW300Config(DeviceType, CPIAddress, SysOptions,
ChanEnable, ResonAmp, LowFreq, HighFreq, ChanOptions,
Mult, Offset, SteinA, SteinB, SteinC, RF_MeanBins,
RF_AmpBins, RF_LowLim, RF_HighLim, RF_Hyst, RF_Form)
CDM_VW300Dynamic
Captures dynamic VSPECT
(p. 532) measurements from the CDM-VW300 dynamic
vibrating-wire spectrum analyzer.
Syntax
CDM_VW300Dynamic(CPIAddress, DestFreq, DestDiag)
CDM_VW300Rainflow
Retrieves rainflow histogram data from the CDM-VW300 vibrating-wire
measurement peripheral.
Syntax
CDM_VW300Rainflow(CPIAddress, RF1, RF2, RF3, RF4, RF5, RF6,
RF7, RF8)
CDM_VW300Static
Retrieves static VSPECT
(p. 532) measurements from the CDM-VW300 vibrating-
wire measurement device.
559

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4