Campbell CR1000 User Manual

Appendix A. CRBasic Programming
Instructions
Related Topics:
• CRBasic Programming — Overview (p. 86)
• CRBasic Programming — Details (p. 122)
• CRBasic Programming — Instructions (p. 537)
• Programming Resource Library (p. 169)
• CRBasic Editor Help
All CR1000 CRBasic instructions (p. 518) are listed in this appendix.
• An alphabetical listing is in the index under Instruction.
• Code examples are throughout this manual and can be located with help from
the Table of Contents CRBasic Examples listing.
• Parameter listings, application information, and code examples are available
in CRBasic Editor
(p. 125) Help.
A.1 Program Declarations
Instructions used in program declarations are usually placed in a program prior to
the BeginProg() instruction.
AngleDegrees
Sets math functions to use degrees instead of radians.
Syntax
AngleDegrees
EncryptExempt
Defines one or more PakBus addresses to which the datalogger will not send
encrypted PakBus messages, even though PakBus encryption is enabled.
Syntax
EncryptExempt(BeginPakBusAddr, EndPakBusAddr)
PipelineMode
Configures the CR1000 to perform measurement tasks separate from, but
concurrent with, processing tasks.
Syntax
PipelineMode
SequentialMode
Configures datalogger to perform tasks sequentially.
Syntax
SequentialMode
537

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4