Section 4. System Quickstart
4.7.5.5 Procedure: (PC200W Steps 7 to 10)
7. Click the OneMin box so a check mark appears in the box. Under What to
Collect, select New data from datalogger. This selects the data to be
collected.
8. Click on a table in the list to highlight it, then click Change Table's Output
File... to change the name of the destination file.
9. Click on Collect. A progress bar will appear as data are collected, followed by
a Collection Complete message. Click OK to continue.
10. To view data, click the
icon at the top of the PC200W window to open
the View utility.
Figure 14. PC200W View Data Utility
58
To Next Page
Loading...
