Campbell CR1000 User Manual

Appendix G. Supporting Products Lists
UT10 3 meter (10 ft) free-standing tower, aluminum
UT20
6 meter (20 ft) free-standing tower, aluminum,
guying is an option
UT30
10 meter (30 ft) free-standing tower, aluminum,
guying is an option
CM375
10 meter (30 ft) mast, galvanized and stainless
steel, requires guying.
CM300
0.58 meter (23 in) mast, stainless steel, free
standing, tripod, and guyed options
CM305
1.2 meter (47 in) mast, stainless steel, free
standing, tripod, and guyed options
CM310
1.42 meter (56 in) mast, stainless steel, free
standing, tripod, and guyed options
G.12 Enclosures List
Table 233. Protection from Moisture — Products
Model Description
6714
Desiccant 4 Unit Bag (Qty 20). Usually used
in ENC enclosures to protect the CR1000.
A150-L
Single Sensor Terminal Case, Vented
w/Desiccant.
4091
Desiccant 0.75g Bag. Normally used with
Sentek water content probes.
25366
CS450, CS451, CS455, and CS456
Replacement Desiccant Tube. Normally used
with CS4xx sensors.
10525
Desiccant and Document Holder, User
Installed. Normally use with ENC enclosures.
3885 Desiccant 1/2 Unit Bag (Qty 50).
CS210 Enclosure Humidity Sensor 11 Inch Cable.
660

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4