Section 5. System Overview
The battery is rated from -55 °C up to 85 °C.
5.4 Datalogger Support Software — Overview
Reading List:
• Datalogger Support Software — Quickstart (p. 46)
• Datalogger Support Software — Overview
(p. 95)
• Datalogger Support Software — Details
(p. 450)
• Datalogger Support Software — Lists
(p. 654)
Datalogger support software are PC or Linux software available from Campbell
Scientific that facilitate communication between the computer and the CR1000.
A wide array of software are available, but most of the heavy lifting gets done by
the following:
• Short Cut Program Generator for Windows (SCWin) — Short Cut is used to
write simple CRBasic programs without the need to learn the CRBasic
programming language. Short Cut is an easy-to-use wizard that steps you
through the program building process.
• PC200W Datalogger Starter Software for Windows — Supports only direct
serial connection to the CR1000 with hardwire or spread-spectrum radio. It
supports sending a CRBasic program, data collection, and setting the CR1000
clock. PC200W is available at no charge at www.campbellsci.com/downloads
(http://www.campbellsci.com/downloads).
• LoggerLink Mobile Apps — Simple tool that allows an iOS or Android
device to communicate with IP-enabled CR1000s. It includes most PC200W
functionality.
• PC400 Datalogger Support Software — Includes PC200W functions,
CRBasic Editor, and supports all telecommunication modes (except satellite)
in attended mode.
• LoggerNet Datalogger Support Software — Includes all PC400 functions and
supports all telecommunication options (except satellite) in unattended mode.
It also includes many enhancements such as graphical data displays.
Note More information about software available from Campbell Scientific can be
found at www.campbellsci.com http://www.campbellsci.com. Please consult with
a Campbell Scientific application engineer for a software recommendation to fit a
specific application.
95
To Next Page
Loading...
Need help?
General
