Campbell CR1000 User Manual

Section 7. Installation
used to access them.
• No single interface accesses all Status/Settings/DTI. Interfaces used for
access include the following:
Table 6. Status/Setting/DTI: Access Points
Access Point Locate in...
Settings Editor
Device Configuration Utility, LoggerNet Connect screen,
PakBus Graph. See Datalogger Support Software — Details
(p.
450).
Status
View as a data table in a numeric monitor
(p. 521).
DataTableInfo
View as a data table in a numeric monitor
(p. 521).
Station Status
Menu item in datalogger support software
(p. 654).
Edit Settings
Menu item in PakBusGraph software.
Settings
Menu item in CR1000KD Keyboard Display Configure,
Settings
status.keyword/settings.keyword
Syntax in CRBasic program
1
Information presented in Station Status is not updated automatically. Click the Refresh button to update.
Note Communication and processor bandwidth are consumed when generating
the Status and DataTableInfo tables. If the CR1000 is very tight on processing
time, as may occur in very long or complex operations, retrieving the Status table
repeatedly may cause skipped scans
(p. 487).
Status603/Settings/DTI (p. 603)can be set or accessed using CRBasic instructions
SetStatus() or SetSetting().
For example, to set the setting StationName to BlackIceCouloir, the following
syntax is used:
SetSetting("StationName","BlackIceCouloir")
where StationName is the keyword for the setting, and BlackIceCouloir is the set
value.
Settings can be requested by the CRBasic program using the following syntax:
x = Status.[setting]
where Setting is the keyword for a setting.
For example, to acquire the value set in setting StationName, use the following
statement:
x = Status.StationName
7.7.1.4 Configuration with Executable CPU: Files
Many CR1000 settings can be changed remotely over a telecommunication link
either directly, or as discussed in section Configuration with CRBasic Program
(p.
115),
as part of the CRBasic program. These conveniences come with the risk of
inadvertently changing settings and disabling communications. Such an
occurence will likely require an on-site visit to correct the problem if at least one
of the provisions discussed in this section is not put in place. For example,
115

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4