Campbell CR1000

Appendix A. CRBasic Programming Instructions
Syntax
CDM_VW300Static(CPIAddress, DestFreq, DestTherm, DestStdDev)
CPISpeed
Controls the speed of the CPI bus.
Syntax
CPISpeed(BitRate))
MuxSelect
Selects the specified channel on a multiplexer.
Syntax
MuxSelect(ClkPort, ResPort, ClkPulseWidth, MuxChan, Mode)
SDMAO4
Sets output voltage levels in an SDM-AO4 continuous-analog-output device.
Syntax
SDMAO4(Source, Reps, SDMAdress)
SDMAO4A
Sets output voltage levels in an SDM-AO4A continuous-analog-output device.
Syntax
SDMAO4A(Source, Reps, SDMAdress)
SDMCAN
Reads and controls an SDM-CAN interface.
Syntax
SDMCAN(Dest, SDMAddress, TimeQuanta, TSEG1, TSEG2, ID,
DataType,
SDMCD16AC
Controls an SDM-CD16AC, SDM-CD16, or SDM-CD16D control device.
Syntax
SDMCD16AC(Source, Reps, SDMAddress)
SDMCD16Mask
Controls an SDM-CD16AC, SDM-CD16, or SDM-CD16D control device.
Unlike the SDMCD16AC, it allows the CR1000 to select the ports to activate via
a mask. Commonly used with TimedControl().
Syntax
SDMCD16Mask(Source, Mask, SDMAddress)
560