Campbell CR1000 User Manual

Appendix A. CRBasic Programming Instructions
device that has the PPP/IP key enabled, such as when the CR1000 IP stack is
used.
DHCPRenew
Restarts DHCP on the ethernet interface.
Syntax
DHCPRenew
EMailRecv
Polls an SMTP server for email messages and stores the message portion of the
email in a string variable.
Syntax
variable = EMailRecv("ServerAddr", "ToAddr", "FromAddr",
"Subject", Message, "Authen", "UserName", "PassWord",
Result)
EMailSend
Sends an email message to one or more email addresses via an SMTP server.
Syntax
variable = EMailSend("ServerAddr", "ToAddr", "FromAddr",
"Subject", "Message", "Attach", "UserName", "PassWord",
Result)
EthernetPower
Controls power state of all Ethernet devices.
Syntax
EthernetPower(state)
FTPClient
Sends or retrieves a file via FTP.
Syntax
Variable = FTPClient("IPAddress", "User", "Password",
"LocalFileName", "RemoteFileName", PutGetOption)
HTTPGET
Sends a request to an HTTP server using the Get method.
Syntax
HTTPGET( URI, Response, Header)
HTTPOut
Defines a line of HTML code to be used in a datalogger-generated HTML file.
Syntax
WebPageBegin("WebPageName", WebPageCmd)
HTTPOut("<p>html string to output " + variable + " additional
594

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4