8. Hold the edge of the roll paper as you gently pull it evenly with both hands to the position of the Ejection Guide (a).
Align the right side of the roll paper with the Paper Alignment Line (b), keeping this side parallel to the line, and
then lower the Release Lever.
Important
• Do not omit steps 7 and 8. If paper cannot be advanced straight or if it wrinkles, it may jam or rub
against the Printhead.
• Do not force the roll paper into alignment with the paper alignment line (b). This may prevent the
paper from being advanced straight.
Note
• You can adjust the strength of suction holding paper against the Platen when the Release Lever is
released. If it is difficult to load paper, press the ▲ or ▼ button on the Control Panel to adjust the
strength. Set suction stronger by pressing the ▲ button or weaker with the ▼ button. Three settings
are available.
Handling Paper
>
Handling rolls
>
Loading Rolls in the Printer iPF8300
7
782
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...
