Bravo-Brava Bodywork
Replacing structural body panels
70.
Welding replacement outer panel
1.
Carry out spot welding on the edges in contact with the internal panel.
2.
Continue the spot welding working from inside the vehicle, continuing the welding on the internal
panel and on the edges of the bodyshell.
3. Carry out spot welding on the edges of the front cross member.
Preparing and welding the brackets
1.
Make equidistant holes in the edges of the brackets.
2.
Remove the anti-corrosion treatment from the entire perimeter of the inside and the outside of the re-
placement part using a rotating brush.
3. Apply the electro-galvanizing paint to the areas previously treated.
3. Using the MIG welder carry out welding filling the holes made previously.
Proceed with fitting the front pillar (see: "Replacing Structural Panels - Replacing Front Pillar").
Copyright by
Fiat
Auto
115
To Next Page
Loading...
