SECTION 5 - R EMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
59
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
If the tool (2) is difficult to fit, loosen the screws (3) and direct
the phonic wheel (1) properly so as to position the tool (2)
on the tooth correctly.
Tighten the screws (3).
Ref.
No. Description
Tightening
torques
(3) 4 M8X1.25 screws 24.5 ± 2.5 Nm
Remove tools 99360612 and 99360613.
High pressure pump assembly
Bring the flywheel to 36˚ before TDC of the first cylinder.
NOTE This position can be obtained by turning the
engine flywheel in the opposite direction to the
operating direction in the 30˚ position marked by
THREE notches (4) and continuing to turn the
flywheel in the same direction until reaching the
next hole (by 6˚).
If the engine flywheel does not have 3 notches, to
identify the reference hole simply: turn the
flywheel in the opposite direction to the operating
direction until reaching the position marked with
2notches(54˚ before cyl. 1 T.D.C.); continue
rotating in the engine operating direction for 3
holes (remember that each hole corresponds to
a flywheel rotation of 6˚).
Insert the specific tool 99360612 through the seat of the
flywheel sensor into the corresponding hole on the flywheel.
Figure 175
221104
Position the bracket (3) and tighten the screws (1,2).
Position the high pressure pump (6) and tighten the screws (4,
5).
Ref.
No. Description
Tightening
torques
(1) 2 ScrewsM10X1.5X20 37.5±5Nm
(2) 3 Screws M8 X 1.25 X 20 24.5 ± 2.5 Nm
(4) 2 Screws M12 X 1.75 X 30 32.5 ± 2.5 Nm
(5) 4 Screws M12 X 1.5 37.5 ± 2.5 Nm
Figure 176
187918
!
Fit the high pressure pump and make sure that
the seat of the key (1) on the pump shaft is facing
the pump intakes (2) .
To Next Page
Loading...
