FPT CURSOR Series - Page 152

4
SECTION 6 - GENERAL MECHANICAL OVERHAUL
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Page
- High pressure pump flange assembly 73........
- Fitting camshaft 74.........................
- Assembling the engine brake cylinders 76.......
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE TOP PART 2) 77....
- Injector assembly 77.......................
- Rail installation 77.........................
- Fitting rocker shaft assembly 78...............
- Camshaft timing 79........................
- Phonic wheel timing 82.....................
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE INTAKE SIDE) 83...
- High pressure pump assembly 83.............
- Intake and exhaust rocker arm
clearance adjustment 85....................
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE TOP PART 3) 86....
- Tappet cover assembly 86...................
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE INTAKE SIDE) 86...
- Fuel filter assembly 86......................
- Inlet manifold assembly 87...................
- Starter motor assembly 88...................
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE REAR PART 2) 88...
Page
- Timing gear assembly cover mounting 88.......
- Blow-by filter fitting 88......................
- Blow-by case fitting 89......................
- Assembly of rpm and timing sensor 89.........
ASSEMBLY OF ENGINE AT BENCH
(COMPONENTS AT THE EXHAUST SIDE) 89.
- Heat exchanger assembly 89.................
- Turbocharger assembly 90...................
- Exhaust manifold assembly 90................
- Thermostat case assembly 91................
- Crankshaft front gasket installation 91..........
- Assembly of auxiliary parts 92................
- Electromagnetic coupling assembly 92..........
- Alternator support assembly 92...............
- Alternator assembly 93
.....................
- Alternator/water pump drive belt assembly 93...
- Damper flywheel installation 93...............
- Removing the engine from the rotating stand 94..
ENGINE ASSEMBLY 94......................
- Asembly of bracket interference components 94.
- Assembly of G-Drive components 96..........
CHECKS 97................................