3. Mode
36080
5/9
36080
Printer Mechanical Adjustment
8. Adjust the adjusting screw of the exposure advance unit inlet roller. (one adjusting screw)
Carry out adjustment for the advance error that is measured in ☞2 of Exposure Advance Unit Zigzagging Adjustment
referring to the following table.
When the measurement value on the LEFT is longer
When the measurement value on the RIGHT is longer
IMPORTANT
• Tighten the fixing screw of the exposure advance roller while the angle bracket of the pressure roller unit is
pressed in the direction indicated by the arrow.
Paper advance
error
(mm)
Rotation direction of the
screw
Rotation amount
of the screw
0.2 to 0.3 Counterclockwise Approximately 45°
0.4 Counterclockwise Approximately 60°
0.6 Counterclockwise Approximately 90°
0.9 Counterclockwise Approximately 135°
Paper advance
error
(mm)
Rotation direction of the
screw
Rotation amount of the
screw
0.1 to 0.2 Clockwise Approximately 45°
0.3 Clockwise Approximately 60°
0.5 Clockwise Approximately 90°
0.9 Clockwise Approximately 135°
Inlet roller nut
Inlet roller
fixing screw
Inlet roller
adjusting screw
Exit roller fixing
screw
Exit roller nut
Exit roller adjusting screw
Pressure guide
G072393
Pressure guide
Screwdriver
G072394
Distributed by: minilablaser.com
To Next Page
Loading...