Printer Mechanical Adjustment
1/2
3. Mode
36100
36100
White Border Width Correction
Bringing up the display
Maintenance → Extension → Maintenance → Various Adjustment → Printer Mechanical Adjustment → White Border Width Correction
!
!!
! Explanation
The margin can be corrected for each paper width and surface.
IMPORTANT
• Perform the correction with any of paper magazine A, A2, B or C.
• This correction affects the exposure position both of prints with border and without border, because the image
exposure position is corrected.
!
!!
! Paper Magazine (Input range: from 82.5 to 305 mm)
Specify the paper magazine to be corrected.
!
!!
! Left Margin Correction (Initial value: 5.0 mm) (Input range: from 0.0 to 10.0 mm)
Correct the left margin of the test print so that it becomes 5.0 mm.
!
!!
! Right Margin Correction (Initial value: 5.0 mm) (Input range: from 0.0 to 10.0 mm)
Correct the left margin of the test print so that it becomes 5.0 mm.
!
!!
! Functions
!
!!
! Test Print (Paper Magazine A/A2/B/C)
Invalidate the correction value to make a test print.
NOTE
• A piece of paper with the advance length of 216 mm and the margin of 5.0 mm is printed.
• The paper width, [A ####(#)] is printed as the CVP imprinting.
!
!!
! Test print confirmation (Paper Magazine A/A2/B/C)
Validate the correction value to make a test print.
M5385-00
Distributed by: minilablaser.com
To Next Page
Loading...