11/15
4. Troubleshooting
46000
46000
Error message: Printer 1
No. 06081
Backup data error. Printer
IMPORTANT
• If the error message above appears, it cannot be closed for approx. 5 to 10 minutes until the Maintenance Display is
shown.
Error message release
NO
Condition
NOTE
• The value informed from CPU is displayed in the last three digits of the suffix number.
• If about 5 days has passed with the power supply off or if the printer control PCB is replaced with a new one, this error message will
be shown.
IMPORTANT
• If the error message above appears, the backup data for the printer control PCB saved in printer I/F main PCB is sent to
the printer control PCB within approx. 5 to 10 minutes while the error cannot be canceled.
If the backup data is sent normally, the error above can be closed.
However, the backup data saved in the printer I/F main PCB may have a problem. If the error above occurs, we
recommend you to read the backup data on the media saved at the close down check.
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
Suffix number Condition
0###H • The backup data of the printer control PCB is abnormal.
• The new printer control PCB is attached.
• The RAM of printer control PCB is broken.
• The power supply of backup for printer control PCB is shut off.
1###H • The backup data of the printer control PCB is abnormal.
• Backup data of the printer I/F main PCB does not exist.
If the data was deleted Manual No.
Read the backup data saved in media at the close down check.
☞35400
Failed part Manual No.
Printer control PCB
☞66000
Printer I/F main PCB
☞66005
Distributed by: minilablaser.com
To Next Page
Loading...