Error message: Printer 3
1/21
4. Troubleshooting
46200
46200
Error message: Printer 3
No. 06203
Setup error.
Error message release
YES
Condition
IMPORTANT
• It occurs when an abnormal correction value is calculated. Confirm that the color density state of the test print have not
changed too much in comparison with the previous print.
NOTE
• See the setup print judgment flow at the daily setup. ☞56620
Diagnosis
The countermeasure action and the failed part would differ depending on the suffix number.
If the test print color density is normal
Suffix number Condition
#2001 When measuring the daily setup test print, the density for specific colors between steps did not rise
consecutively.
#2002 The Dmax of the measured daily setup print was 3.8 or more, and the daily setup Dmax data for 15 days were not
ready.
#2003 The Dmax of the measured daily setup print was 3.8 or more, and the daily setup Dmax data for 15 days did not
change consecutively day by day and changed suddenly.
#2004 The Dmax is within the range of 0.9 and 3.8, but when calculating the daily setup correction value, the correction
value for specific colors was over 10 times as high as the previous value.
#2005 When calculating the daily setup correction value, the correction value for specific colors was 3 key or more.
#2006 When calculating the daily setup correction value, the total amount of the correction value (specified color) after
completing the initial setup or paper specification registration setup exceeded the limit value.
Suffix
number
Countermeasure and failed part Manual No.
#2002
#2003
#2004
#2005
#2006
Clean the calibration plate. −
Replace the calibration plate if it is scratched on.
☞27460
#2001
#2002
#2002
#2004
#2005
#2006
Colorimeter unit
☞27460
Processor control PCB
☞66200
Between steps
G083195
Distributed by: minilablaser.com
To Next Page
Loading...