Attention message: Main controller/ Setting module
1/2
4. Troubleshooting
49450
49450
Attentio n message: Main c ontroller/ Set ting module
No. 10000−15302
Refer to the Troubleshooting Manual for Corrective action of Attention message.
Condition
IMPORTANT
• Attention messages not explained in this Service Manual are listed in the table.
For corrective actions for the messages, see the EZ Controller Troubleshooting Manual, EZ Controller Service
Manual and T15/LS Connecting Unit Operator's Manual.
*1. Attention messages in the 10500s are for the Multi Purpose Format Creation Software.
For details about each attention message, see the Multi Purpose Format Creation Software Operator's Manual.
T15/LS Connecting Unit Operator's Manual
Attention: Main controller/ Setting module
Attention message table
No. 10100 Order Reservation cannot be executed.
No. 10101 A reserved order remains. Would you like to insert film manually?
No. 10102 Cannot start film processing as scanner is not available.
Attention message table
No. 10000 Are you sure you want to quit the application?
No. 10001 Are you sure you want to delete the order?
No. 10003 Select the Same Service Name.
No. 10004 Processing of the print has been started. Failed to interrupt.
No. 10005 Invalid setting data is included. Check the print channel setting.
No. 10006 Could not start printing as the printer is not powered on.
No. 10007 An order is in process. Would you like to stop processing?
No. 10008 There are some devices for which closedown checks are not completed. Are you sure you want to quit the
application?
No. 10200 Additional scanning is not allowed as order number has been incremented.
No. 10201 Unable to hold the correction values as image size has been changed.
No. 10300 There is no data in the specified path. Specify the correct path.
No. 10302 Would you like to restart the EZ Controller to read the data?
No. 10304 Could not cancel as the end processing has started.
No. 10305 If you change the setting, you will have to set up the registered print channel again. Are you sure you want
to change the setting?
No. 10306 Cannot register the printer.
No. 10307 Set up the scanner.
No. 10308 The scanner you have selected is not installed. Select another scanner.
No. 10309 Cannot register with the paper size selected.
No. 10310 Cannot manipulate as order is being processed.
No. 10311 Printer registration has been changed. EZ Controller will restart.
No. 10312 The main printer has been designated for this group. Would you like to change the main printer?
No. 10313 Cannot delete the printer. Change the main printer.
No. 10400 The file was not found for showing the error/attention message for the printer.
No. 10401 The Paper Setup was not executed.
No. 10500
*1
Would you like to stop editing the information?
No. 10501
*1
Would you like to delete the selected template?
No. 10502
*1
Registration was completed.
No. 10503
*1
There is insufficient space left on the disk. Increase the free space of disk then retry.
No. 10504
*1
This template has more than 16 layers. This template cannot be used.
Distributed by: minilablaser.com
To Next Page
Loading...