EasyManua.ls Logo

Fujitsu PRIMERGY RX2520 M1 - Basic Procedures; Inch HDD; SSD Configurations; Mounting Order for 2.5-Inch Hdds; Ssds

Fujitsu PRIMERGY RX2520 M1
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
122 Upgrade and Maintenance Manual
RX2520 M1
Hard disk drives / solid state drives
7.1 Basic procedures
Solid state drives (SSDs) are always equipped before installing hard disk
drives
Solid state drives are only available for 2.5-inch HDD versions
Hard disk drives / solid state drives with different capacities are installed
from highest to lowest capacity.
Hard disk drives with different rotation speeds are installed from highest to
lowest speed.
When installing hard disk drives with different bus technologies (SAS or
SATA), first install SAS drives and then SATA drives.
Please refer to sections "Mounting order for 2.5-inch HDDs / SSDs" on
page 122 and "Mounting order for 3.5-inch HDDs" on page 133 for a
complete overview of the mounting sequence.
Install dummy modules into unused HDD / SSD bays.
I The mounting order described above is only relevant for the factory
manufacturing process. In case of upgrading a system you need not
consider this mounting sequence.
7.2 2.5-inch HDD / SSD configurations
7.2.1 Mounting order for 2.5-inch HDDs / SSDs
Maximum configuration: 16x 2.5-inch HDDs / SSDs
Basic information
Solid state drives (SSDs) are always equipped before installing hard disk
drives.
If only one HDD/SSD module is installed, the HDD/SSD module will be
installed in position 1. Empty bays must be equipped with a dummy module.

Table of Contents

Other manuals for Fujitsu PRIMERGY RX2520 M1

Related product manuals