Fujitsu PRIMERGY RX2520 M1 - Removing the Defective System Board

366 Upgrade and Maintenance Manual RX2520 M1
System board and components
14.6.2 Removing the defective system board
Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see section "Removing processor heat sinks" on page 248
I Leave the processor on the defective board for now.
– Memory modules: see section "Removing memory modules" on
page 227
I Ensure to take note of the memory modules’ mounting positions
for reassembly.
– Expansion cards: see section "Removing expansion cards" on page 186
I Ensure to take note of the controllers’ mounting positions and
cable connections for reassembly.
– UFM: see section "Removing the UFM" on page 340
– onboard SAS enabling key: see section "Removing the onboard SAS
enabling key" on page 360
– SAS RAID controller: see section "Removing the SAS RAID controller"
on page 194