9.4.3.2 Removing the defective SAS RAID controller
Ê "Removing the SAS RAID controller" on page 194
Ê If the RAID card holder on the defective controller is to be reused, remove it
from the board as described in section "Removing the SAS RAID card
holder" on page 195.
9.4.3.3 Installing the new SAS RAID controller
Ê If applicable, install the RAID card holder on the new SAS RAID controller
as described in section "Preparing the SAS RAID controller" on page 191.
Ê "Installing the SAS RAID controller" on page 191
9.4.3.4 Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I For a complete cabling overview, please refer to section "List of used
cables" on page 393.
9.4.3.5 Connecting a backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 198.
9.4.3.6 Concluding steps
Ê "Reassembling" on page 59
Ê "Connecting the server to the power source" on page 64
Ê "Switching on the server" on page 66
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 80.
Ê "Enabling SVOM boot watchdog functionality" on page 87
Ê "Enabling BitLocker functionality" on page 93
Ê "Updating RAID controller firmware" on page 79
To Next Page
Loading...
