14.3.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 67
Ê "Disabling SVOM boot watchdog functionality" on page 68
Ê "Locating the defective server" on page 49
Ê "Shutting down the server" on page 51
Ê "Disconnecting power cords" on page 52
Ê "Getting access to the component" on page 53
14.3.3.2 Removing the UFM
Ê "Removing the UFM" on page 340
Ê The UFM spacer remains on the system board.
14.3.3.3 Installing the new UFM
Figure 233: Preparing the new UFM
Ê Remove the nylon screw from the new UFM (1).
Tools: – Phillips PH0 / (+) No. 0 screw driver
– combination pliers and flat nose pliers
To Next Page
Loading...
