11.3 Removing processors
11.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 67
Ê "Disabling SVOM boot watchdog functionality" on page 68
Ê "Shutting down the server" on page 51
Ê "Disconnecting power cords" on page 52
Ê "Getting access to the component" on page 53
Ê "Removing processor heat sinks" on page 248
11.3.2 Removing a processor
I This description applies to the following procedures:
– Removing the second processor (CPU 2) from a dual-processor
configuration
– Removing processors from a defective system board (see section
"Removing a processor" on page 238)
Ê Remove the desired processor heat sink as described in section "Removing
processor heat sinks" on page 248.
Upgrade and Repair Unit
(URU)
Hardware: 15 minutes
Software: 5 minutes
Tool: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
