Viewing the SEL using the iRMC web frontend
Ê Enter the ServerView iRMC web frontend.
Ê Select the Event Log and choose the Internal Event Log submenu.
Ê Under Internal Event Log Content the SEL is being displayed. In order to filter
the list, select the check boxes next to the desired event types and press
Apply for the changes to take effect.
I For detailed information on iRMC settings, refer to the "Integrated
Remote Management Controller" user guide.
5.2.12.2 Clearing the SEL
You can clear the System Event Log (SEL) using the ServerView iRMC web
frontend:
Ê Enter the ServerView iRMC web frontend.
Ê Select the Event Log and choose the Internal Event Log submenu.
Ê Under Internal Event Log Information click Clear Internal Event Log to clear the
SEL.
I For detailed information on iRMC settings, refer to the "Integrated
Remote Management Controller" user guide.
5.2.13 Updating the NIC configuration file in a Linux
environment
In order to prevent errors caused by changing network device names (eth<x>),
it is recommended to store the MAC address (hardware address) of a network
interface card in the related NIC configuration file of the Linux OS.
When replacing a network controller or the system board with onboard LAN
controllers in a server running Linux OS, the MAC address will change but not
automatically be updated in the definition file.
In order to prevent communication problems, it is necessary to update the
changed MAC address stored in the related ifcfg-eth<x> definition file.
To update the MAC address, proceed as follows:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
