Fujitsu PRIMERGY RX2520 M1 - Connecting Cables to the Expansion Card; Connecting a Backup Unit to the Expansion Card; Concluding Steps

RX2520 M1 Upgrade and Maintenance Manual 193
Expansion cards and backup units
9.4.1.4 Connecting cables to the expansion card
Ê Connect SAS cables to the SAS RAID controller.
I For a complete cabling overview, please refer to section "List of used
cables" on page 393.
9.4.1.5 Connecting a backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 198.
9.4.1.6 Concluding steps
Ê "Reassembling" on page 59
Ê "Connecting the server to the power source" on page 64
Ê "Switching on the server" on page 66
Ê In order to configure an expansion card that has been installed or replaced,
the card’s Option ROM has to be enabled in the system board BIOS. If
applicable, proceed as described in section "Enabling Option ROM scan" on
page 80.
Ê "Enabling SVOM boot watchdog functionality" on page 87
Ê "Enabling BitLocker functionality" on page 93
Ê "Updating RAID controller firmware" on page 79