15.3.2.6 Steps
Ê "Disabling or suspending BitLocker functionality" on page 67
Ê "Shutting down the server" on page 51
Ê "Disconnecting power cords" on page 52
Ê Remove all external cables.
Ê "Getting access to the component" on page 53
Ê "Removing the fan box" on page 168
Ê "Removing the front cover" on page 376
Ê Remove the HDD cage 1 and 2, see "Removing a HDD cage" on page 158.
Ê "Installing a LTO drive in the cage" on page 297
Ê "Installing the LTO cage" on page 299
Ê For more information about the cabling see "Configuration 3" on page 400.
Ê "Installing the fan box" on page 171
Ê "Installing the front cover 2.5-inch version" on page 377
Ê "Reassembling" on page 59
Ê Connect all external cables.
Ê "Connecting the server to the power source" on page 64
Ê Update your server’s chassis information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section "Using the Chassis ID
Prom Tool" on page 97.
Ê "Enabling BitLocker functionality" on page 93
To Next Page
Loading...
