Fujitsu PRIMERGY RX2520 M1 - Installing an Expansion Card; Connecting Cables to the Expansion Card; Connecting a Battery Backup Unit to the Expansion Card; Concluding Steps

190 Upgrade and Maintenance Manual RX2520 M1
Expansion cards and backup units
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing the slot bracket" on
page 184.
9.3.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 177.
Ê "Installing expansion cards" on page 183.
Ê If applicable, "Installing SFP+ transceiver modules" on page 212.
9.3.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 393.
9.3.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect a FBU to the expansion card as described in section
"Installing a FBU" on page 198.
9.3.3.6 Concluding steps
Ê "Reassembling" on page 59
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 64
Ê "Switching on the server" on page 66
Ê "Enabling replaced components in the system BIOS" on page 87
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 94.
Ê "Updating RAID controller firmware" on page 79
Ê "Enabling SVOM boot watchdog functionality" on page 87
Ê "Enabling BitLocker functionality" on page 93