Fujitsu PRIMERGY RX2520 M1 - Removing Memory Modules; Preliminary Steps; Removing a Memory Module

RX2520 M1 Upgrade and Maintenance Manual 227
Main memory
10.3 Removing memory modules
10.3.1 Preliminary steps
Ê "Disabling or suspending BitLocker functionality" on page 67
Ê "Disabling SVOM boot watchdog functionality" on page 68
Ê "Locating the defective server" on page 49
Ê "Shutting down the server" on page 51
Ê "Disconnecting power cords" on page 52
Ê "Getting access to the component" on page 53
10.3.2 Removing a memory module
Ê Identify the desired memory slot see section "Memory sequence" on
page 223.
V CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Basic information" on page 222.
Figure 119: Removing memory modules (A)
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory slot.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: tool-less