Fujitsu PRIMERGY RX2520 M1 - Installing a 3.5-Inch Dummy Module; Concluding Steps; Replacing a 3.5-Inch HDD Module

140 Upgrade and Maintenance Manual RX2520 M1
Hard disk drives / solid state drives
7.3.3.3 Installing a 3.5-inch dummy module
V CAUTION!
If the removed HDD module is not replaced immediately, always replace
a dummy module into the unused HDD bay to comply with applicable
EMC regulations and satisfy cooling requirements.
Figure 47: Installing a 3.5-inch dummy module
Ê Slide the 3.5-inch dummy module into the drive bay until it locks in place.
7.3.3.4 Concluding steps
Ê "Performing a RAID array rebuild" on page 94
7.3.4 Replacing a 3.5-inch HDD module
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less