CHAPTER 9: BOOTCODE AND FIRMWARE UPGRADE 9.2 FIRMWARE UPGRADE VERSION 7.00 OR ABOVE
GEK-106310-AF F650 DIGITAL BAY CONTROLLER 9-29
through cable for hub or switch).
3. Set the appropriate IP address in the relay.
4. Set the appropriate IP address in the PC.
5. In the EnerVista 650 Setup software, select C
ommunication > Upgrade Relay.
6. Select the appropriate file (DCL0
00CAXXX.SDF) for the upgrade.
7. Enter the IP address, serial number, and unit identifier of the relay as prompted.
8. Click Upgrade F
ile to initiate the upgrade process.
9. Reboot the relay as required by the upgrade program to complete the upgrade process.
10. All setting and configuration are now set to the factory default.
11. Send new settings and configuration files to the relay if needed.
See chapter 13 F650 trouble shooting guide, if there is any problem during the upgrading
process.
To Next Page
Loading...