D-22 F650 DIGITAL BAY CONTROLLER GEK-106310-AF
D.6 IEC 60870-5-104 INTEROPERABILITY APPENDIX D: IEC 60870-5-104 PROTOCOL
Parameter loading
(object-specific parameter, mark "X" if function is only used in the standard direction, "R" if only used in the reverse
direction, and “B” if used in both directions).
Parameter activation
(object-specific parameter, mark "X" if function is only used in the standard direction, "R" if only used in the
reverse direction, and "B" if used in both directions).
Test procedure
(station-specific parameter, mark "X" if function is only used in the standard direction, "R" if only used in the
reverse direction, and "B" if used in both directions).
File transfer
(station-specific parameter, mark “X” if function is used).
File transfer in monitor direction
File transfer in control direction
Background scan
(station-specific parameter, mark "X" if function is only used in the standard direction, "R" if only used in the
reverse direction, and "B" if used in both directions).
X Threshold value
Smoothing factor
Low limit for transmission of measured values
Low limit for transmission of measured values
Act/deact of persistent cyclic or periodic transmission of the addressed object
Test procedure
Transparent file
Transmission of disturbance data of protection equipment
Transmission of sequences of events
Transmission of sequences of recorded analogue values
Transparent file
Background scan
To Next Page
Loading...