BGS2T AT Command Set
7.21 AT+CLCC
BGS2T_ATC_V01.301 Page 161 of 554 1/31/12
c
3 Voice followed by data, voice mode (only in connection with single numbering
scheme AT+CSNS)
4 Alternating voice/data, voice mode (only in connection with single numbering
scheme AT+CSNS)
5 Alternating voice/fax, voice mode (only in connection with single numbering
scheme AT+CSNS)
6 Voice followed by data, data mode (only in connection with single numbering
scheme AT+CSNS)
7 Alternating voice/data, data mode (only in connection with single numbering
scheme AT+CSNS)
8 Alternating voice/fax, fax mode (only in connection with single numbering
scheme AT+CSNS)
9 Unknown
0 Call is not one of multiparty (conference) call parties
1 Call is one of multiparty (conference) call parties
Phone number in format specified by <type>
Type of address octet as defined by 3GPP TS 24.008 [32], subclause 10.5.4.7. For possible values see the
<type> parameters specified for phonebook related AT commands, for example AT+CPBR and AT+CPBW.
145 Dialing string <number> includes international access code character '+'
161 National number
128 Number is restricted
129 Otherwise
Alphanumeric representation of <number> corresponding to the entry found in phonebook (see for example
AT+CPBW, parameter <text>).
Due to time constraints on the necessary evaluation of the phonebook, this parameter may show a default value
in early call phases (e.g. for <stat>= ''dialing'', ''incoming'' or ''alerting''), even if a phonebook entry is present
for the number concerned.
Note
• Teleservices other than voice, data, fax are not fully supported by ME. They are used only in connection with
the handling for AT+CSNS, and may therefore occur in parameter <mode> for mobile terminated calls.
<mpty>
(num)
<number>
(str)
<type>
(num)
<alpha>
(str)(+CSCS)
To Next Page
Loading...
