BGS2T AT Command Set
16.7 AT^SPBG
BGS2T_ATC_V01.301 Page 497 of 554 1/31/12
c
Last index number in the sorted list where to stop reading. The supported range is given in the test command
response.
If <index2> is not given via write command, only the entry located at <index1> will be displayed.
If both <index1> and <index2> are in the range indicated by the test command parameter <used>, the list
of entries will be output and terminated with OK.
If <index2> exceeds the range indicated by the test command parameter <used>, the list of entries will be
output but terminated with a "+CME ERROR: invalid index".
Is a display of the "real" <location> of the entry required?
[0] Do not show an entry's "real" location number. Parameter <location> will not
be displayed.
1 Show the "real" location number as parameter <location> at the end of each
entry.
String type phone number in format specified by <type>.
The number parameter may be an empty string.
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with ATD><mem><n> is, depending
on the network, not always possible (refer to 3GPP TS 24.008 [32] subclause 10.5.4.7 for details). See also
<type> of AT+CPBW.
Possible values are:
145 Dialing string <number> includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string <number> has been saved as ASCII string and includes non-
digit characters other than "*", "#", "+" or "p". Note that phonebook entries
saved with this type cannot be dialed.
255 Dialing string <number> is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
Text assigned to the phone number. The maximum length for this parameter is given in test command response
<tlength>.
Value indicating the number of used locations in selected memory storage.
The location within phonebook memory at which the corresponding entry is located.
This location may be used for other commands (e.g. AT+CPBR or ATD><mem><n>)
Maximum length of phone number for "normal" locations. Depending on the storage, a limited number of loca-
tions with extended memory is available per phonebook. Please refer to AT command AT+CPBW for detail.
<index2>
(num)
<RealLocReq>
(num)
<number>
(str)
<type>
(num)
<text>
(str)(+CSCS)
<used>
(num)
<location>
(num)
<nlength>
(num)
To Next Page
Loading...
Need help?
General
