IBM Storwize V7000 Unified - Example that Shows that a Drive Is Not Synchronized

7. See Figure 48 on page 104 for an example of status when there is no mirror.
If mirroring is not enabled, the output under Mirror Information displays a
message that says: The mirror is not created/configured.
If the mirror is not created, refer to “Troubleshooting the System x3650” in the
IBM Storwize V7000 Unified Information Center for information on launching the
LSI configuration tool.
Target on ID #5
Device is a Hard disk
Enclosure # : 1
Slot # : 1
Connector ID : 1
Target ID : 5
State : Out of Sync (OSY) <---
Size (in MB)/(in sectors) : 286102/585937500
Manufacturer : IBM-ESXS
Model Number : XXXXXXXXXXXX
Firmware Revision : XXXX
Serial No : XXXXXXXXXXXXXXXXXXXX
Drive Type : SAS
Protocol : SAS
Error Information
SMART Error Count : none
SMART ASC : none
SMART ASCQ : none
Figure 47. Example that shows that a drive is not synchronized
Chapter 4. File module 103