6. The system detects the USB flash drive, reads the satask.txt file, runs the
command, and writes the results to the USB flash drive. The satask.txt file is
deleted after the command is run.
7. Wait for the fault LED on the node canister to stop flashing before removing
the USB flash drive.
8. Remove the USB flash drive and insert it into your workstation to view the
results.
9. Use a web browser to view the results file, satask_result.html.
Check that there were no errors returned by the command. If there is
insufficient battery charge to protect the system, the clustered system creates
successfully, but it does not start immediately. In the results, look for the
time_to_charge field for the battery. The results provide an estimate of the
time, in minutes, before the system can start. If the time is not 0, wait for the
required time. Check that the node canister that you inserted the USB flash
drive into has its clustered-state LED on permanently. For additional
information, see “Procedure: Understanding the Storwize V7000 Gen1 system
status using the LEDs” on page 262.
10. If the initialization was successful and the batteries are sufficiently charged,
point a supported browser to the management IP address that you specified
to start the management GUI. You see the management GUI logon panel.
11. Log on as superuser. Use passw0rd for the password.
12. Follow the on-screen instructions.
Results
For more information about using the USB flash drive, see “USB flash drive and
Initialization tool interface” on page 206.
Procedure: Initializing a clustered system using the service
assistant
Use this procedure to initialize a clustered system using the service assistant. This
procedure differs, depending on the generation of your control enclosure model.
About this task
Storwize V7000 Unified Gen1 refers to the enclosure models in the following table:
Table 97. Storwize V7000 Unified Gen1 model numbers
Machine
type/model Description
2076-112 Storwize V7000 Unified control enclosure for up to 12 3.5-inch (8.89
cm) drives
2076-124 Storwize V7000 Unified control enclosure for up to 24 2.5-inch (6.35
cm) drives
2076-312 Storwize V7000 Unified control enclosure for 3.5-inch drives (with two
10 Gbps iSCSI/FCoE Ethernet ports)
2076-324 Storwize V7000 Unified control enclosure for 2.5-inch drives (with two
10 Gbps iSCSI/FCoE Ethernet ports)
2076-212 Storwize V7000 Unified expansion enclosure for 3.5-inch drives
2076-224 Storwize V7000 Unified expansion enclosure for 2.5-inch drives
Chapter 5. Control enclosure 273
To Next Page
Loading...
Need help?
General
