IBM Storwize V7000 Unified Problem Determination Guide

About this task
Attention: If your drive is configured for use, go to the management GUI and
follow the fix procedures. Initiating the replacement actions without the assistance
of the fix procedures results in loss of data or loss of access to data.
Attention: Do not leave a drive slot empty. Do not remove a drive or drive
assembly before you have a replacement available.
To replace the drive assembly or blank carrier, perform the following steps:
Procedure
1. Read the safety information to which “Preparing to remove and replace parts”
on page 295 refers.
2. Unlock the module by squeezing together the tabs at the top.
3. Open the handle to the full extension.
svc00614
Figure 100. Unlocking the 2.5 inch drive
Chapter 5. Control enclosure 327

IBM Storwize V7000 Unified Specifications

General

Model	IBM Storwize V7000 Unified
Storage Type	Unified Storage
RAID Levels	RAID 0, 1, 5, 6, 10
Form Factor	2U
Drive Types Supported	SAS, SSD
Maximum Drives	504
Network Protocols	iSCSI, FC, FCoE
Drive Bays	24 per enclosure
Host Interface	8 Gb FC, 1 Gb/10 Gb iSCSI
File Protocols	NFS, CIFS
Block Protocols	iSCSI, Fibre Channel
Type	Unified Storage
Maximum Host Ports	16
Operating System Support	VMware, Microsoft Windows, Linux, AIX
Data Services	Thin provisioning, replication
Power Supply	Redundant power supplies
Host Interfaces	8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI