v ▌3▐ Ethernet port 8
v ▌4▐ Ethernet port 9
v ▌5▐ Ethernet port 10
v ▌6▐ Power supplies ( 1 is lower 2 is upper)
v ▌7▐ Ethernet port 1 (connected to the other file module)
v ▌8▐ Ethernet port 2 (connected to the other file module)
v ▌9▐ Ethernet port 7
v ▌10▐ Ethernet port 3
v ▌11▐ Ethernet port 4
v ▌12▐ Systems-management Ethernet port (NOT USED)
v ▌13▐ Video port
v ▌14▐ Serial port
v ▌15▐ Ethernet port 5 (10 Gbps)
v ▌16▐ Ethernet port 6 (10 Gbps)
v ▌17▐ USB ports
Components in the front of the enclosure
This topic describes the components in the front of the enclosure.
Drives for control enclosures
Storwize V7000 Unified enclosures use different drives, depending on the
generation of your control enclosure model. An enclosure can hold up to 12 3.5 in.
(8.89 cm) drives or up to 24 2.5 in. (6.35 cm) drives.
Storwize V7000 Gen1
The drives are in the front of the enclosure. The 12 large form factor 3.5 in. (8.89
cm) drives are mounted horizontally in four columns with three rows.
The 24 small form factor 2.5 in. (6.35 cm) drives are mounted vertically in one row.
Important: Drive slots cannot be empty. Install a drive assembly or blank carrier in
each slot.
Note: Drives that are sold as Storwize V7000 Unified options are the only drives
that are supported. For more information, see the Support website for more
information.
Figure 6 shows 12 drives and Figure 7 on page 5 shows 24 drives.
Figure 6. Storwize V7000 Gen1 Drives on a 12-drive enclosure
4 Storwize V7000 Unified: Problem Determination Guide 2073-720