IBM Storwize V7000 Unified Problem Determination Guide

Syntax
►► satask setsystemip -systemip ipv4 -gw ipv4 -mask ipv4 -consoleip ipv4 ►◄
Parameters
-systemip
The IPv4 address for Ethernet port 1 on the system.
-gw
The IPv4 gateway for Ethernet port 1 on the system.
-mask
The IPv4 subnet for Ethernet port 1 on the system.
-consolip
The management IPv4 address of Storwize V7000 Unified system.
Description
This command is only supported in the satask.txt file on a USB flash drive.
It calls the svctask chsystemip command if the USB flash drive is inserted in the
configuration node canister, Otherwise it will blink the amber identify LED of the
node canister that is the configuration node.
If the amber identify LED for a different node canister starts to blink then move
the USB flash drive over to that node canister because it is the configuration node.
When the amber LED turns off you can move the USB flash drive to one of the file
modules so that it will use the clitask.txt file to change the file module
management IP addresses.
Leave the USB flash drive in the file module for at least two minutes before you
remove it. Use a workstation to check the clitask_results.txt and satask.txt results
files on the USB flash drive.
If the IP address change was successful then you must run the startmgtsrv -r
command to restart the management service so that it will not continue to ssh
commands to the old system IP address of the volume storage system.
For example, on a Linux workstation with network access to the new management
IP address:
satask setsystemip -systemip 123.123.123.20 -gw 123.123.123.1 -mask 255.255.255.0
-consoleip 123.123.123.10
You can now access the management GUI, which you can use to change any other
IP address that needs to be changed.
Here is an example of what could be in the clitask.txt file:
chnwmgt --serviceip1 123.123.123.11 --serviceip2 123.123.123.12
--mgtip 123.123.123.10 --gateway 123.123.123.1 --netmask 255.255.255.0 --force
chstoragesystem --ip1 123.123.123.20
Here is an example of what could be in the satak.txt file:
satask setsystemip -systemip 123.123.123.20 -gw 123.123.123.1 -mask 255.255.255.0
-consoleip 123.123.123.10
214 Storwize V7000 Unified: Problem Determination Guide 2073-720

IBM Storwize V7000 Unified Specifications

General

Model	IBM Storwize V7000 Unified
Storage Type	Unified Storage
RAID Levels	RAID 0, 1, 5, 6, 10
Form Factor	2U
Drive Types Supported	SAS, SSD
Maximum Drives	504
Network Protocols	iSCSI, FC, FCoE
Drive Bays	24 per enclosure
Host Interface	8 Gb FC, 1 Gb/10 Gb iSCSI
File Protocols	NFS, CIFS
Block Protocols	iSCSI, Fibre Channel
Type	Unified Storage
Maximum Host Ports	16
Operating System Support	VMware, Microsoft Windows, Linux, AIX
Data Services	Thin provisioning, replication
Power Supply	Redundant power supplies
Host Interfaces	8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI