EasyManuals Logo

IBM Storwize V7000 Unified Problem Determination Guide

IBM Storwize V7000 Unified
474 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #241 background imageLoading...
Page #241 background image
Create system command:
Use this command to create a storage system.
Note: The reference to cluster is not the same as the file system cluster on the
Storwize V7000 file modules.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
►► satask mkcluster -clusterip ipv4
-gw ipv4 -mask ipv4 -name cluster_name
►◄
►► satask mkcluster -clusterip_6 ipv6
-gw_6 ipv6 -prefix_6 int -name cluster_name
►◄
Parameters
-clusterip ipv4
(Optional) The IPv4 address for Ethernet port 1 on the system.
-gw ipv4
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
-mask ipv4
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
-clusterip_6 ipv6
(Optional) The IPv6 address for Ethernet port 1 on the system.
-gw_6 ipv6
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
-prefix_6 int
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
-name cluster_name
(Optional) The name of the new system.
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Change system IP address:
Use this command to change the system IP address of the storage system.
It is best to use the initialization tool to create this command in satask.txt together
with the associated clitask.txt file that changes the file modules management IP
addresses.
Chapter 5. Control enclosure 213

Table of Contents

Other manuals for IBM Storwize V7000 Unified

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM Storwize V7000 Unified and is the answer not in the manual?

IBM Storwize V7000 Unified Specifications

General IconGeneral
ModelIBM Storwize V7000 Unified
Storage TypeUnified Storage
RAID LevelsRAID 0, 1, 5, 6, 10
Form Factor2U
Drive Types SupportedSAS, SSD
Maximum Drives504
Network ProtocolsiSCSI, FC, FCoE
Drive Bays24 per enclosure
Host Interface8 Gb FC, 1 Gb/10 Gb iSCSI
File ProtocolsNFS, CIFS
Block ProtocolsiSCSI, Fibre Channel
TypeUnified Storage
Maximum Host Ports16
Operating System SupportVMware, Microsoft Windows, Linux, AIX
Data ServicesThin provisioning, replication
Power SupplyRedundant power supplies
Host Interfaces8 Gbps Fibre Channel, 10 Gbps iSCSI, 1 Gbps iSCSI

Related product manuals