IBM Storwize V7000 Unified - Example that Shows that the Mirror Is Not Created

8. See Figure 49 on page 105 for an example of a Self-Monitoring, Analysis and
Reporting Technology (SMART) error found for a hard drive. SMART adds
monitoring and troubleshooting functionality by automatically checking a disk
drive's health and reporting potential problems. If any SMART errors are
detected for a hard drive, you can see the status in the section for Error
Information as shown in Figure 49 on page 105.
Note: In Figure 49 on page 105 the hard disk drive with Target ID #6 has a
ASC/ ASCQ error of 05/00.
For isolation and the repair of hard disk problems, refer to “Troubleshooting
the System x3650” in the IBM Storwize V7000 Unified Information Center.
For a list of SMART (ASC/ASCQ) error codes and their descriptions, go to
“SMART ASC/ASCQ error codes and messages” on page 105.
Mirror Information:
NOTICE: The mirror is not created/configured. <---
Drive Information:
Total number of drives found: 2
Target on ID #4
Device is a Hard disk
Enclosure # : 1
Slot # : 1
Connector ID : 1
Target ID : 4
State : Ready (RDY)
Size (in MB)/(in sectors) : 286102/585937500
Manufacturer : IBM-ESXS
Model Number : XXXXXXXXXXXX
Firmware Revision : XXXX
Serial No : XXXXXXXXXXXXXXXXXXXX
Drive Type : SAS
Protocol : SAS
Error Information
SMART Error Count : none
SMART ASC : none
SMART ASCQ : none
Target on ID #6
Device is a Hard disk
Enclosure # : 1
Slot # : 0
Connector ID : 0
Target ID : 6
State : Ready (RDY)
Size (in MB)/(in sectors) : 286102/585937500
Manufacturer : IBM-ESXS
Model Number : XXXXXXXXXXXX
Firmware Revision : XXXX
Serial No : XXXXXXXXXXXXXXXXXXXX
Drive Type : SAS
Protocol : SAS
Error Information
SMART Error Count : none
SMART ASC : none
SMART ASCQ : none
Figure 48. Example that shows that the mirror is not created
104 Storwize V7000 Unified: Problem Determination Guide 2073-720