Mocom millennium B - TECHNICAL CHARACTERISTICS

Rev.1
Page 1-
7
TECHNICAL CHARACTERISTICS
Equipment Steam sterilizer
Classification (as per
93/42/CEE)
IIa
Manufacturer
M.O.COM. S.r.l.
Via delle Azalee, 1
20090 BUCCINASCO (MI) - ITALY
Power supply 220/240 V
Frequency 50/60 Hz
Mains fuses
(6,3 x 32 mm)
F 16A 250V
PCB fuses (board type
“G”)
(5 x 20 mm)
F1: T 5A 250V (trafo secondary winding
– 24V)
F2: T 2A 250V (digital signal 5V / analog
12V )
F3: T 2A 250V (trafo primary winding
– 230V)
F4: F 200mA 250V (door-locking protection)
F5: F 1.25A 250V (door-locking gear motor
overload)
F1 PTR: T 5 A (printer protection-
optional)
PCB fuses (board type
“T”)
(5 x 20 mm)
F1: T 6,3A 250V (trafo secondary winding)
F2: T 3.15A 250V (trafo primary winding)
F1 PTR: T 3,15A 250V (printer protection -
optional)
External dimensions
(LxDxH)
480 x 560 x 420mm (excluding rear
connections)
Nominal power 2300 W (10A)
Insulation class Class I
Installation category Cat. II
Environment of use Internal use
Noise level <60 db(A) max
Environmental operating
conditions
Temperature: +15°C ÷ +40°C
Relative Humidity: max 80%,
non condensing
Altitude: max 3000 m (a.s.l.)
Net weight
approx. 50 kg (empty)
approx. 55 kg (empty, with trays and
support)
approx. 59 kg (empty, with trays and
supports and water at
Max level)
Sterilization chamber
dimensions (Ø x D)
250 x 350 mm
Sterilization chamber total
volume
about 17 l (0.017 m
3
)
Sterilization chamber useful
volume (with tray supports
inserted)
about 10 l (0.010 m
3
)
Distilled water tank capacity
(supply)
about 4.6 l (water at MAX level)
about 0.8 l (water at MIN level)
Sterilization programs
Available: 11
Pre-sets: 4 (direct selection by
user)
Test programs
HELIX/BD Test
Vacuum Test
Preheating time
(from cold)
about 10 minutes
RS232 serial interface DB-9 pin (female) connector
Bacteriological filter
(PTFE filtering element)
Porosity: 0.2 µm
Connection: male 1/8" NPT connector