Mocom millennium B - Alarm during a cycle; Alarm outside the cycle

Rev. 1
Page 3-
5
Once the door is open, the user is finally asked to reset the system:
(Alarm Message)
RESET SYSTEM
95.5°C XXXX
0.00 bar 11:43
Perform a RESET (described below) and then turn-off the equipment and check the error or make the repair.
e When the door is opened, the report (normal or extended depending on the type of alarm) will be printed for the interrupted sterilization
program and the alarm that intervened. Check the document, initial it in the space provided and file it in a suitable place. Refer to Print
report examples.
Alarm outside the cycle
If the alarm intervenes outside the sterilization or test program the display will show:
(Alarm Message)
ALARM!
80.5°C XXXX
0.00 bar
Turn-off the equipment and check the alarm.
Or, depending on the type of alarm:
(Alarm Message)
WARNING!
80.5°C XXXX
0.00 bar
Depending on the alarm
Alarm code
Alarm code