Rev.1
Page 1-
16
CONNECTING DEMINERALIZER MILLDROP
(OPTIONAL, automatic filling option)
The sterilizer can be connected to MILLDROP (water treatment reverse osmosis system) warranting the automatic reservoir filling with high
quality demineralized water.
Refer to MILLDROP operating manual for the installation instructions:
– Connect the supplied water filling tube to the rear fitting point; lock with clip.
– Connect the supplied START/STOP cable to the rear jack connector.
– Switch on the MILLDROP.
– Switch on the sterilizer and set the filling option (see chapter “Setting tank filling mode”.
For additional information and advice about the correct connection of the sterilizer to the various water purification systems, contact
M.O.COM. Customer Service .
Clip
Water filling tube
(from demineralizer)
Start/stop cable
Jack
connector
To Next Page
Loading...
