Mocom millennium B - FIRST START-UP; Turning on; Initial automatic test

Rev.1
Page 1-
55
FIRST START-UP
Turning on
Once the sterilizer has been correctly installed, it may be turned on and prepared for use.
Turn on the equipment by the main (luminous) switch located on the right side of the machine.
e Do this with the sterilizer's door open.
Initial automatic test
When turned on, the control panel lights up and beeps so you can visually check its correct operation. The panel then displays this message:
MILLENNIUM B
R. Exxxx/BMyyyyyy
DEVICE CHECK-UP
e If the door is closed, the test is interrupted. The panel then beeps and displays the following message:
OPEN THE DOOR
TO CONTINUE
Open the door to allow the test to continue. At the end of the test you will see:
MILLENNIUM B
Rev. Exxxx/BMyyyyyy
CHECK-UP COMPLETE