Mocom millennium B - Acquisition and Updating the Ambient Pressure Values

Rev.1
Page 1-
20
ACQUISITION AND UPDATING THE AMBIENT PRESSURE VALUES
The sterilizer measures the ambient pressure
for the correct operation of several auxiliary devices. Whenever the difference between the value
read and that previously stored (see the Chapter, “Configuring the Device - Acquisition the ambient pressure) is higher than a set value,
the system automatically updates the stored value after a brief delay. Otherwise, the data remains unchanged without updating.
After updating, the device performs the initial automatic test procedure (see Initial self test). At the end, the display shows the following notice
(accompanied by a beep):
AMBIENT PRESSURE
VALUE UPDATED
-0.01 bar
↵ to continue
When ↵ is pressed, the device goes to STAND-BY mode .