Mocom millennium B - ACTIVATING CONFIGURATION OPTIONS - ADVANCED MENU; Setting the Printer mode

Rev.1
Page 1-
36
Setting the Printer mode
(PRINT OPTIONS on the ADVANCED menu)
When the sterilizer is equipped with a printer (option) for recording sterilization program data; it is necessary to set the parameters required for its
proper operation:
1. Select PRINT OPTIONS using the ↵ key and the following menu appears:
→ PRINTER +
REPORT ↑
EXIT ↓
-
Select PRINTER to select the settings for the printer used, or REPORT to set the number of copies to print and to reprint data from the last
program executed.
a) Item PRINTER
The following screen appears:
→ OFF +
INTERNAL ↑
EXTERNAL ↓
EXIT -
Select OFF to deactivate the printing of data at the end of a sterilization (or test) cycle.
Select INTERNAL to enable the thermal printer set inside the front of the sterilizer. In this case, another menu opens:
→ TYPE 1 +
TYPE 2 ↑
EXIT ↓
-