Rev. 1
Card Gr4-
3
HEAT EXCHANGER
C#1BP1600000
Before servicing, switch off the equipment and unplug the power
supply cable from the mains socket
1. Remove the covers (see card Gr7-1 );
2. Remove the rear grid (1);
3. Move out the group as possible and remove the sheathed pipes;
4. Separate the heat exchanger (3) from the its frame (2);
5. Mount the new heat exchanger, assembly all items and restore connections
proceeding in reverse order as above;
6. Run a sterilization cycle.
2
3
1
To Next Page
Loading...
