Rev.1
Page 1-
21
CONFIGURATION
General
Millennium B offers personalization options never previously seen on any steam sterilizer. Users may configure the device to meet their own
needs. For example, the device's performance may be adapted on the basis of the type of activity, the type of material to be sterilized or its
frequency of use.
The SETUP program allows selecting from numerous options that users activate through an intuitive, easy-to-use menu.
e Use the SETUP program whenever necessary. A correctly personalized device provides the best performance and the most satisfactory
use.
e Customer Service by M.O.COM is available to help users by providing suggestions or advice on the best way to uses the options in the
SETUP program.
Starting and entering the Setup Mode
To start the SETUP program, hold down the
key on the control panel for several seconds, until the display shows:
MILLENNIUM B
SETUP
↵ to continue
to exit
e Icon SETUP on the display lights-up and stays on or the entire configuration phase.
When you press the ↵ key, you enter the SETUP mode. The screen shows the first-level menu items (see the paragraph SETUP Flowchart).
Pressing the ESC key quits the SETUP program and takes you back to normal operation (stand-by mode).
e The SETUP program can only be started in STAND-BY mode. It is not accessible during sterilization or test cycles.
To Next Page
Loading...
