Rev. 1
Page 2-
8
If Millflash is connected
Dependent on the device connected, the equipment checks also the presence of the Compact Flash card. If not plugged in, the display shows:
WARNING
CF CARD MISSING
↵ to continue
↑ to exit
Plug in the CF card in the recording device and press the key ↵ on the command panel.
Push the key ↑ to interrupt the start command and return in Stand-by mode.
In case of the card memory full or insufficient to store the new cycle data, the following message will be displayed:
WARNING
CF CARD FULL
↵ to continue
↑ to exit
or
WARNING
MEMORY FULL
↵ to continue
↑ to exit
Push key ↵ to continue without recording the cycle data.
Push key ↑ to interrupt the start command; download the files on PC and delete the memory content according to the instructions of the Millflash
Operating Manual.
Repeat the Start command.
To Next Page
Loading...
